Sharp MX-2314N - Page 229

MX-3114N SIMULATION 6 – 96
53-9
Purpose
Adjustment
Function (Purpose)
Used to set dirt detection for RSPF scan-
ning position.
Operation/Procedure
1) Select an items to be set with scroll key.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
53-10
Purpose
Adjustment/Setup
Function (Purpose)
RSPF dirt detection execution.
Section
Operation/Procedure
1) Press [EXECUTE] key.
55
55-1
Purpose
(Do not use this function unless specially
required.)
Function (Purpose)
Used to set the specifications of the engine
control operations. (SOFT SW)
Section
Operation/Procedure
55-2
Purpose
(Do not use this function unless specially
required.)
Function (Purpose)
Used to set the specifications of the scan-
ner control operation. (SOFT SW)
Section
Operation/Procedure
55-3
Purpose
(Do not use this function unless specially
required.)
Function (Purpose)
Used to set the specifications of the control-
ler operation. (SOFT SW)
Section
Operation/Procedure
55-10
Purpose
Adjustment/Setting
Function (Purpose)
Used to set the special stamp text. (Taiwan
only)
Section
Operation/Procedure
1) Select an item to be set (digit, color, type) with the scroll key.
2) Enter the value corresponding to the setting item with 10-key.
3) Press [OK] key.
Item/Display Content
Setting
range
Default
value
A DIRT_ALARM_SET OFF RSPF dirt alarm setting OFF 0 - 1 0 1
(OFF)
ON ON 1
B SIDEA_SCAN_POSITION_SET_START OFF RSPF front surface optimum scan position detection
setting (When starting)
OFF 0 - 1 0 1
(ON)
ON ON 1
C SIDEA_SCAN_POSITION_SET_JOB OFF RSPF front surface optimum scan position detection
setting (After a job)
OFF 0 - 1 0 1
(ON)
ON ON 1
D SIDEA_SCAN_POSITION_LV WEAK RSPF front surface optimum scan position detection
level setting
Low 0 - 2 0 1
(MIDDLE)
MIDDLE Medium 1
STRONG High 2
E OC_DIRT_LV WEAK OC dirt level setting Low 0 - 2 0 1
(MIDDLE)
MIDDLE Medium 1
STRONG High 2
F SIDEA_DIRT_ALARM_LV WEAK RSPF front surface dirt alarm level setting Low 0 - 2 0 1
(MIDDLE)
MIDDLE Medium 1
STRONG High 2
G SIDEA_DIRT_SHADING_SET OFF RSPF front surface streak delete shading setting OFF 0 - 1 0 1
(ON)
ON ON 1
Item Content
SPF SIDEA RSPF front surface dirt detection position (main scan
position 1 to 8)
"-": No dirt, A"*": Dirt
OC OC surface dirt detection position (main scan position
1 to 8)
"-": No dirt, "*": Dirt
Item/Display Content
Setting
range
Default
value
A 1ST DIGIT First digit (left edge) 1 - 90 1
B 2ND DIGIT Second digit
C 3RD DIGIT Third digit 32 [blank:
20H]
D 4TH DIGIT Fourth digit 65 - 90
[Alphabet:
41H("A) -
5AH("Z")]
E 5TH DIGIT Fifth digit 48 - 57
[Numeral:
30H("0") -
39H("9")]
F 6TH DIGIT Sixth digit (right
edge)
G COLOR K Color specification
input
00
C1
M2
Y3
R4
G5
B6