Sharp MX-2314N - Page 313

MX-3114N MAINTENANCE 9 – 14
Option
✕: Check (Clean, replace, or adjust according to necessity.) : Clean : Replace : Adjust ✩: Lubricate
Option
name
Unit work
sequence
Unit name
Parts work
sequence
Part name
When
calling
At the
machine cycle
Remark
Stand/
500 sheet
paper drawer
1 Tray 2 paper feed unit 1 Paper pickup roller ✕  Replace at 100K of each tray paper
feed counter or 1 year of use.
2 Paper feed roller ✕ 
3 Separation roller ✕ 
4 Transport roller 1 ✕ 
5 Torque limiter ✕✕Replace at 100K of each tray paper
feed counter.
6Sensors ✕✕
– Paper guides Clean with alcohol.
2 1CS drive unit 7 Gears (grease) ✕✕Apply to the specified position
when checking.
HANARL FL-955R
8 Shafts (grease) ✕✕Apply to the specified position
when checking.
FLOIL G-313S
Stand/
2x500 sheet
paper drawer
1 Tray 2 paper feed unit 1 Paper pickup roller ✕  Replace at 100K of each tray paper
feed counter or 1 year of use.
2 Paper feed roller ✕ 
3 Separation roller ✕ 
4 Transport roller 1 ✕ 
5 Torque limiter ✕✕Replace at 100K of each tray paper
feed counter.
6Sensors ✕✕
– Paper guides Clean with alcohol.
2 Tray 3 paper feed unit 7 Paper pickup roller ✕  Replace at 100K of each tray paper
feed counter or 1 year of use.
8 Paper feed roller ✕ 
9 Separation roller ✕ 
10 Vertical transport roller 1 ✕ 
11 Transport roller 3 ✕ 
12 Torque limiter ✕✕Replace at 100K of each tray paper
feed counter.
13 Sensors ✕✕
– Paper guides Clean with alcohol.
3 1CS drive unit 14 Gears (grease) ✕✕Apply to the specified position
when checking.
HANARL FL-955R
15 Shafts (grease) ✕✕Apply to the specified position
when checking.
FLOIL G-313S
4 2CS drive unit 16 Gears (grease) ✕✕Apply to the specified position
when checking.
HANARL FL-955R
17 Shafts (grease) ✕✕Apply to the specified position
when checking.
FLOIL G-313S
Stand/
3x500 sheet
paper drawer
1 Tray 2 paper feed unit 1 Paper pickup roller ✕  Replace at 100K of each tray paper
feed counter or 1 year of use.
2 Paper feed roller ✕ 
3 Separation roller ✕ 
4 Transport roller 1 ✕ 
5 Torque limiter ✕✕Replace at 100K of each tray paper
feed counter.
6Sensors ✕✕
– Paper guides Clean with alcohol.
2 Tray 3 paper feed unit 7 Paper pickup roller ✕  Replace at 100K of each tray paper
feed counter or 1 year of use.
8 Paper feed roller ✕ 
9 Separation roller ✕ 
10 Vertical transport roller 1 ✕ 
11 Transport roller 3 ✕ 
12 Torque limiter ✕✕Replace at 100K of each tray paper
feed counter.
13 Sensors ✕✕
– Paper guides Clean with alcohol.