Sharp MX-3070N

To Next Page

To Previous Page

7-10

SYSTEM SETTINGS►USER CONTROL

Printer Settings

U: General user; A: System administrator/Administrator

Setup Items Factory default setting U A

● Printer Settings (page 7-81)

X Condition Settings No Yes

 Prohibit Notice Page Printing Enabled No Yes

 Prohibit Test Page Printing Disabled No Yes

 A4/Letter Size Auto Change Disabled No Yes

 Print Density Level No Yes

• Colour 3 (Normal) No Yes

• Black & White 3 (Normal) No Yes

 CMYK Exposure Adjustment All 0 No Yes

 Bypass Tray Settings No Yes

• Enable Detected Paper Size in Bypass Tray Disabled No Yes

• Enable Selected Paper Type in Bypass Tray Disabled No Yes

• Exclude Bypass-Tray from Auto Paper Select Disabled No Yes

 Job Spool Queuing Enabled No Yes

 Disabling of USB Memory Direct Print Disabled No Yes

 Disabling of Network Folder Direct Print Disabled No Yes

 Disabling sending while printing Disabled No Yes

X Interface Settings No Yes

 Hexadecimal Dump Mode Disabled No Yes

 I/O Timeout 60sec. No Yes

 Enable Network Port Enabled No Yes

 Network Port Emulation Switching Auto No Yes

 Port Switching Method Switch at End of Job No Yes

X Initial Status Settings Yes Yes

 No. of Prints 1 sets of copies Yes Yes

 Orientation Portrait Yes Yes

 Default Paper Size A4 Yes Yes

 Default Output Tray Varies depending on the machine

configuration

Yes Yes

 Default Paper Type Plain Yes Yes

 Initial Resolution Settings 600dpi (High Quality) Yes Yes

 Disable Blank Page Print Disabled Yes Yes

 Two Sided One Sided Yes Yes

 Colour Mode Auto Yes Yes

 N-Up Printing 1-Up Yes Yes

 Fit Page Enabled Yes Yes

Other manuals for Sharp MX-3070N