7-13
SYSTEM SETTINGS►USER CONTROL
Image Send Settings
Common Settings
U: General user; A: System administrator/Administrator
Setup Items Factory default setting U A
● Common Settings (page 7-113)
X Condition Settings No Yes
Hold settings for a while after scanning has been
completed
Disabled
No Yes
Job Auto Start Time During Scanning 60sec.
Default Display Settings Fax No Yes
Address Book Default Selection No Yes
• Higher priority is given to the display of address
book.
Disabled
No Yes
• Apply Addresses of Sending Modes Only Enabled No Yes
Category Displayed as Default None No Yes
Display all address type regardless of the mode being
displayed currently.
Disabled
No Yes
Enlarge Address Book Enabled No Yes
Image Orientation Portrait No Yes
Initial Exposure Settings Auto No Yes
Default Original Image Type Characters No Yes
Sending the same image sent in Fax/I-Fax mode Disabled No Yes
Be sure to press Next Address Key ([+]) before
selecting the next address.
Disabled
No Yes
Scan Complete Sound Setting Middle No Yes
Disable Switching of Display Order Disabled No Yes
Hold Setting for Received Data Print Disabled No Yes
Default Verification Stamp No Yes
• E-mail/Scan/Data Entry Disabled No Yes
• Fax/Internet Fax Disabled No Yes
Erase Width Adjustment No Yes
• Edge Clearance Width 10mm No Yes
• Centre Clearance Width 10mm No Yes
Time Specified Output of Received Data Disabled No Yes
X Enable/Disable Settings No Yes
Settings to Disable Registration No Yes
• Disable Registering Destination from Operation
Panel
All Invalid
No Yes
• Disable Registering Destination on Web Page All Invalid No Yes
• Disable Registration/Deletion of All Program Items Disabled No Yes
To Next Page
Loading...
