Parameter Description
5. Parameter Description
(1) Sensorless vector control and closed loop control
5.77 Motor Control Mode (P.300 and P.301)............................................................................................. 168
5.78 Motor Parameter (P.302~P.312) ....................................................................................................... 171
5.79 Gain Adjustment at Speed Control (P.320~P.325) ............................................................................. 172
5.80 Torque limit range setting(P.326) ...................................................................................................... 173
5.81 Feedback Control Parameters (P.350~P.359) ................................................................................... 174
5.82 Torque control parameters (P.400~P.407)......................................................................................... 176
(2) Adjusting the output torque of motor (current)
5.1 Torque Boost (P.0, P.46) ...................................................................................................................... 56
5.11 Stall Prevention (P.22, P.23 and P.66, P.220) ...................................................................................... 67
5.42 Slip Compensation Coefficient (P.89) ............................................................................................... 128
5.48 Zero-Speed Function (P.151~P.152) ................................................................................................ 134
5.49 Over Torque Detection (P.155~P.156, P.260) .................................................................................... 134
5.67 Modulation Coefficient (P.246) ......................................................................................................... 159
(3) Output frequency limit
5.2 The Rage of the Output Frequency (P.1, P.2 and P.18) ......................................................................... 57
5.44 Frequency Jump (P.91~P.96) ........................................................................................................... 129
(4) V/F curve setting
5.3 Base Frequency and Base Frequency Voltage (P.3, P.19 and P.47)...................................................... 58
5.9 Load Pattern Selection (P.14, P.98~P.99, P.162~P.169) ........................................................................ 64
(5) Setting frequency by external terminal
5.4 Multi-speed (P.4~P.6, P.24~P.27 and P.142~P.149) .............................................................................. 59
5.10 JOG Mode (P.15 and P.16) ................................................................................................................ 67
5.30 Remote Setting Function (P.61) ....................................................................................................... 111
(6) The setting of acceleration and deceleration time or mode
5.5 Acceleration / Deceleration Time (P.7, P.8, P.20, P.21,P.44 and P.45).................................................... 60
5.8 Starting Frequency (P.13) .................................................................................................................... 64
5.13 Acceleration / Deceleration Curve (P.29, P.255~P.258) ....................................................................... 69
5.45 Programmed Operation Mode (P.100~P.108, P.111~P.118, P.121~P.123, P.131~P.138) .................... 130
5.47 The selection of positive and reverse rotation dead time (P.119) ....................................................... 133
(7) The selection and protection of motor
5.6 Electronic Thermal Relay Capacity (P.9) .............................................................................................. 62
5.71 Input Phase Failure Protection (P.281) ............................................................................................. 165
5.84 PTC(P.532~P.534) ........................................................................................................................... 179
(8) Braking and stopping of the motor
5.7 DC Injection Brake (P.10, P.11 and P.12) .............................................................................................. 63
5.14 Regenerative Brake (P.30 and P.70) .................................................................................................. 73
5.33 Brake Selection (P.71) ..................................................................................................................... 116
5.65 DC Brake Function before Starting (P.242~P.244) ............................................................................ 157
To Next Page
Loading...
Need help?
General
