MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 12 -
2.7 Printer Configuration
Must configure a printer before printing the trace or report.
Procedure:
1. Turn on printer power.
2. Use USB cable to connect MTP-200 and printer
3. Enter OTDR interface
4. Click the [ ] on the lower right corner, enter Print interface, as Fig. 2.2
shown below
Fig. 2.2 Printer and setting interface
5. In Printer area, until now there is no default printer. Click [ ], it will appear
window as shown below:
To Next Page
Loading...
