MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 25 -
Improperly connected fiber may cause serious loss and reflection.
Please refer to Safety Instructions of this manual before testing to ensure personal safety.
◆ When testing with OTDR, unless connected to specific optical port, please make
sure there is no working laser in the fiber under test or it may cause incorrect result and
even permanent damage to test instrument.
◆ Please not screw connectors too tight or it may damage fiber and optical port.
7 Test with OTDR
7.1 OTDR Quick Test
1. Check the connection between fiber and OTDR optical port, make sure it’s well
connected.
2. Click [Start] icon or press button to start testing.
3. Click [Stop] icon or press button to stop testing.
Fig 7.1 shows the OTDR interface after trace acquisition:
To Next Page
Loading...
