MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 26 -
Fig. 7.1 OTDR Trace Acquisition Interface
◆ Click the [Start] button with stylus or mouse.
◆ During testing, the averaging trace shows in the trace display area and refresh at
certain intervals, the trace after testing finishes is the final trace.
◆ User can stop testing any time, application will show all the information when test
stops.
◆ After test is finished or interrupted by user, system will perform automatic
analysis which takes about 5 seconds or longer before user can start a new test.
◆ In Averaging mode, the interface will show the remaining time of the test.
◆ In Real-time mode, test will keep going until user stops it.
7.2 Trace Processing
After test and automatic analysis is complete, event types will be displayed below the trace
area; user can review all events information in events list which is on {Events} label.
After test and automatic analysis is complete, user can save traces. Please refer to the “Save
Trace”.
After test and automatic analysis is complete, user can view the trace detail and manually
analysis. Please refer to “Trace Viewing and Analysis Operation”.
After test and automatic analysis is complete, user can start a new test after trace acquisition.
To Next Page
Loading...
