MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 24 -
Trace processing includes:
➢ Trace editing (Single trace, multi traces)
➢ Printing (Single trace printing, batch printing)
➢ Trace reanalysis
➢ Trace format conversion
Bi-directional averaging program (for single mode fibers only) is available in advanced
versions to increase loss testing accuracy by averaging the measured loss values of each
event from both directions.
5.6 Available OTDR Module
OTDR module details is in appendix, including wavelength, dynamic range, dead zone and
etc.
6 Prepare to Use OTDR
6.1 Connectors Instruction
The optical ports equipped on MTP-200 are FC/PC (Interchangeable SC, ST and LC)
6.2 Cleaning and Connecting to Optical Fiber
To insure measurement accuracy, please clean and connect fiber properly before testing.
Connecting fiber to OTDR port is tool-free.
➢ Please refer to “Maintenance and Calibration” for optical port and connector
cleaning.
➢ Clean connectors and check if fiber connector type is FC/PC
➢ Connect fiber to OTDR port.
To Next Page
Loading...