MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 74 -
16 OTDR Module Built-in Optical Power Meter
PM100
Optical power meter operation:
Click “OPM” icon to enter Optical Power Meter interface as shown in Fig 16.1.
Fig. 16.1 Optical Power Meter
After the setup, click [Start] button to start the measurement. Click [Stop] button to stop the
measurement.
◆ The function icon turns red while switching on this function module.
◆ The wavelength of OPM will be changed to the current wavelength automatically if the
Modulation set of SLS is Auto ID.
“Unit”: Shift between dBm and W.
“Auto zero”: This function provides an easy method of auto zero of power meter, which can be
used to rectify the instrument’s power value under non-luminous state in daily testing.
To Next Page
Loading...