MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 51 -
current window.
◆ It is better to locate event under whole trace status and then magnify to see the
detail.
11.14.2 Add Event
User can insert event into event sheet at any time manually. For example, when there is a
splice point on some given position, but as it hidden in the noise or the splice loss lower than
the minimum value of non-reflection detecting threshold, then the analysis didn’t test that
point, this operation will be quite useful. User can manually add this event to the event sheet.
This will add a number on the insertion position but won’t modify the trace.
Important Hint: When reanalyze the trace; the inserted event will be removed.
Add event:
1. Press[Add] on {Event} label;
Fig. 11.3 Add event
2. Fill in the event information in the add event dialog window.
To Next Page
Loading...
