MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 86 -
Procedure:
1. Run out of the battery completely.
2. Charge the battery until fully charged.
20.10 Change Battery
1. Power Off MTP-200 and unplug power adaptor.
2. Open the battery dock cover.
3. Change battery.
4. Close the battery dock cover.
◆ Please note if the power indicator on front panel is off before changing battery;
make sure MTP-200 is completely off before changing battery.
◆ Only factory can change clock battery.
20.11 Calibration Requirements
Calibration of MTP-200 is recommended every two years. Please contact our representatives
or nearby customer service centers for proper calibration.
20.12 Shipment
During shipment, please keep MTP-200 in prescribed temperature range.
Please note following points to protect MTP-200 during shipment:
➢ Use original packing materials.
➢ Avoid excessive temperature and humidity change.
➢ Avoid direct exposure to sunlight.
➢ Avoid shock and vibration.
To Next Page
Loading...