MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 29 -
7.5 Auto Naming
System supports auto naming when saving traces.
Procedure:
1. Enable/disable auto naming by checking/unchecking “Auto Naming” in OTDR
Setup.
2. User can edit auto naming rule by modifying file name prefix, input the prefix in
“File Name” field. Please note the prefix is only effective when “Auto Naming”
option is checked.
◆ The file name in auto naming mode consists of: Prefix+Wavelength+Number, the
number will increase automatically when user save traces.
7.6 Open Saved Trace
Click [Open] button on the right lower corner in OTDR interface to open saved trace
1. In single trace display mode, when opening a new trace, the currently-displayed
trace will be closed.
2. In Multi-trace display mode, user can open and display up to four traces at the
same time.
◆ Enable/disable Multi-trace display mode in OTDR Setup by checking/unchecking
“Multi-trace” in Display Option.
◆ User can open and view “.jpg” format trace though “File Explorer” on {Program}
label in MTP-200 main interface. “.jpg” format trace can be also loaded to PC for
viewing.
7.7 Trace Viewing and Analysis Operation
User can zoom in/out trace, utilizing markers and marking points for trace characterization
To Next Page
Loading...
