MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 45 -
◆ For easier using, the position of Markers will be remembered, when open
MTP-200 and trace next time, the Markers will maintain the position operated last
time.
◆ There is marked point when proceed the loss or reflection analysis.
11.6 Switch And Move the Marked Point
When proceed loss or reflection analysis, there will be marked point used for auxiliary test
near the selected Markers.
There are various ways to switch, move the marked point, user can use one of them or use
the combination to increase efficiency.
➢ Use stylus or mouse select marked point in the trace displaying area, then can press
on and drag the marked point move in the trace service area to the target position.
➢ In the buttons area on the interface, click [ ] to switch circulated between the
marked points under current Markers.
➢ After select the point, continuously click [ ] or [ ] can move the point.
The points under each Marker in the process of movement:
◆ Marked points on the left side can’t cross the Markers to the right side
◆ Marked points on the right side can’t cross the Markers to the left side
11.7 Fast Move the Markers Outside the Window
When magnify the trace, Markers may be positioned outside of the window.
When the Markers on the left side outside the window, there will be a sign on the left
margin of the window: A← or B←
When the Markers on the right side outside the window, there will be a sign on the right
margin of the window: →A or →B
Drag the signs above mentioned can move the Markers in to current window.
To Next Page
Loading...