MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 15 -
Power saving mode is on by default, and LCD backlight turn off automatically in 10
minutes.
3.4 Recalibrate Touch Screen
If touch screen is abnormal, you should recalibrate it.
Recalibrate touch screen:
1. Click [Setup] to enter into setting menu.
2. In setup menu, click [System Setup].
3. Double-click [Stylus] icon.
4. Click [Calibration] label and operate following the instructions.
Fig. 3.2 Recalibrate touch screen
5. When system shows “Press enter button to accept new setup”, click the touch
screen with stylus to complete new setting.
Note: Under the main menu interface, user can press “ ” key and enter the calib
ration interface. After calibrating, click the touch screen with stylus and be out of th
e calibration interface to complete the calibration.
Touch screen can be calibrated many times, until you satisfy it.
To Next Page
Loading...
