MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 79 -
Fig. 18.2 Measurement
5.Click [Stop] button or Re-Press “ ”（Start/Stop）button on MTP-200 front panel to stop
the measurement.
6. Exit this OCI interface: Click the exit button in the upper left corner; it will back to the main
interface.
◆ In order to obtain a clear image, user needs to adjust focal length of probe and the
brightness and contrast of image.
◆ If the probe is connected to the OCI before starting the application, user has to restart
the application to Initializes.
18.2 Adjust the Image’ Brightness and Contrast
Adjust the brightness with interface brightness slider.
Adjust the contrast with interface contrast slider.
To Next Page
Loading...
