MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 43 -
System can open 4 traces at the same time. When need to open other traces, please close
some opened traces.
11.3 Close Trace File
Close trace file:
Click [Close trace] button on the upper right corner of the interface to close the trace
file.
Using tip: when under single trace mode (none multi traces mode), open new trace will close
the opened trace automatically, this will reduce the operating steps and make it easier to use.
11.4 Trace Display and Operating Instruction
After trace opened, application program will display the trace and analysis result in the trace
window. The events on the trace will be marked by small icons, these events marked and
display below the trace.
X axis shows the relative distance from the testing point.
The number on the Y axis shows the reflection power value (relative power) and its range.
After get the trace, the trace display parameters can be revised (like grid line and zoom
window screen). Please refer to the paragraphs of “trace display parameters configuration”
The content of trace window changes according to options changing. Some items of trace
can be saw all the time, but other items displayed when select to display them or switch the
options from one to another.
To Next Page
Loading...