MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 35 -
Revert to the values when leave factory
Tab. 9.2 OTDR test parameters setting sheet
9.3 OTDR display and other Configuration
It is including setting of save method, testing display area and etc. Parameters setting in this
part won’t affect the testing result.
If be selected, the trace files saving will adopt auto naming, the
content in file name editing frame will be used as prefix of auto
naming; if not be selected, the auto naming won’t be used, need
to enter file name.
If be selected, the grid line will be displayed when trace be
displayed, otherwise not be displayed.
If be selected, then support multi trace testing and display,
otherwise only test single trace and display.
If be selected, there will be a trace navigator window on the
upper right on the trace window, it’s easier to check the
contracted drawing of whole trace. Meanwhile, can check or
move magnify the windows position.
If not be selected, can’t see the navigator window and system
default select “navigator window”.
If be selected, there will be a zoom toolbar on the right side of
the trace window; if not be selected, there will be no zoom
toolbar but a bigger trace display zone.
Set the length unit displayed.
Tab. 9.3 OTDR display or other parameters setting
9.4 Real time and average test mode
Under sampling and accumulating condition, test mode has real time and average mode.
1. Under real time mode, instrument test the external optical fiber connection in real
time and refresh display testing trace in real time. When instrument working under
real time mode, user click [Stop] or press “ ”(Start/Stop) on front panel, the
test will be stopped or the test will proceeding all the time.
2. Under average mode, instrument accumulate and average the testing data according
to the time user choose, test time is equal or greater than test time user set, display
To Next Page
Loading...