MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 55 -
➢ Change the finish threshold (optical fiber end threshold): It can analyze the
important loss event (like breakpoint) and stop the event analysis after that event.
“Auto” mode and “Manual” mode can use these thresholds.
Set analysis detecting threshold
1. Press [Setup] in the button area which in the lower right area to enter setting
surface.
2. Set these parameters in the parameters analysis part. In the relative edit frame,
enter value needed or press [Default] revert the default value.
Fig. 11.8 Parameters analysis edit frame
3. Press [OK] to save setting and then quit setting surface; If press [Cancel], it will
quit without setting saved.
Analysis detecting threshold just set will used for trace tested after the set and reanalysis of
the trace.
11.16 Reanalyze the Trace
User can reanalyze the trace. Reanalyze the trace has follow effects:
➢ Create new event sheet for trace.
➢ Reanalyze the trace got by the software of latest version.
To Next Page
Loading...
