MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 73 -
15 OTDR Module Built-in Stabilized Laser Source
LS100
Under “Source”,
interface is shown as Fig 15.1
Fig.15.1
“Wavelength”: Same as the wavelength of OTDR, wavelengths can be selectable.
“Modulation”: Select different modes at CW, 270Hz, 1KHz, 2KHz、Auto ID.
After the setup, click [Start] button to start the measurement. Click [Stop] button to stop the
measurement.
The function icon turns red while switching on this function module.
To Next Page
Loading...