MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 28 -
Fig. 7.2 Save dialog window
◆ Title bar shows the current folder path, as shown in Fig 7.2:
“\SDMMC_DISK\Traces\”.
◆ System will automatically enter newly created folder.
◆ After file is saved, file name will be displayed on left upper corner of trace display
area. Please note only the first 10 characters of the file name will be displayed and
the rest are abbreviated as a “~” mark.
◆ The file name can be set automatically by the system, and the name prefix can be
modified.
◆ Enable/disable auto naming by checking/unchecking [Auto naming] in OTDR
Setup.
◆ User can modify the prefix of the name in the <Storage> [File Name] in OTDR
Setup. Only when the [Auto naming] is enable, the name prefix can be in effect.
◆ If the name of the file to be saved already exists, system will promote a warning
message.
◆ For DWDM OTDR, if user select more than one wavelength, OTDR will test one
wavelength after another and automatically save all traces in AutoSave folder.
OTDR will display the trace of the last tested wavelength.
To Next Page
Loading...
