MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 57 -
➢ Navigation window: It can display or hide the window which used for whole trace
survey on the upper right position of the trace window.
➢ Length unit: it can select the length unit will be used in the whole application
program.
Before the trace opened, it can change following trace display options:
➢ Multi traces: Control whether to open multi traces at the same time
➢ Zoom toolbar: It can display or hide the zoom icon area which on the right side;
will get maximized trace display area after hide the zoom toolbar. The zoom
toolbar is displayed under default status.
For the first time entering OTDR functions surface, the help information for simple
operation displayed in the trace area and can’t see the navigation window and grid line. Only
after test or after the trace opened can see the grid line and navigation window.
To set the trace display parameters:
1. To press [Setup] in the button bar which on the lower right of the OTDR menu.
2. In the options of test display area, select and modify the display options.
3. Press [Application] and make change become effective, then quit the setting dialog
box; or press [Cancel] to quit the setting dialog box without setting save.
Fig. 11.9 Options of test display area
To hide or display the zoom toolbar must turn off all the trace opened. Otherwise the setting
won’t go into effect.
To Next Page
Loading...
