ShinewayTech MTP-200 Series - Page 76

MTP-200 Series User’s Manual
Shineway Technologies, Inc. - 63 -
3. Zoom the trace to view the event clearly, move Marker A to the end of linear part
of the trace before the event;
4. Move the first marking point to the beginning of the linear part of the trace before
the event;
5. Move the second marking point to the end of the linear part of the trace before the
event;
6. Move the third marking point to the beginning of the linear part of the trace after
the event;
7. Move the fourth marking point to the end of the linear part of the trace after the
event;
Fig. 12.4 Measure insertion loss in 5-point method
◆ The marking points on the left of the active marker cannot be moved the right and
vice versa.
◆ The loss showed in the Event List is measured by 5-point method.