SICK FLOWSIC100 Flare - Page 139

Assembly and Installation
FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH 139
Subject to change without notice
Connecting FLSE100 EX-S/EX-PR
– S/R units: Ex zone 1 without Exe terminal compartment, CSA CI I, Div1/Div2
– MCUP: without explosion protection, Ex zone 2 or CSA CI I, Div2 or CSA CI I, Div1
Fig. 69 FLOWSIC100 EXS/EXPR cabling
gnd
+24 V DC
RS485a
RS485b
gnd
+24 V DC
RS485a
RS485b
br
ws
gn
ge
+24 V DC
GND
a-unit A
b-unit A
ws br gn ge
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
com n.c. n.o.
com n.c. n.o.
com n.c. n.o.
com n.c. n.o.
com n.c. n.o.
RS485b
RS485a
+24 V DC
gnd
ge
gn
ws
br
Slave
Slave
FLSE100 Slave
Master
FLSE100 Master
Master
MCUP processor board
on-site cabling in explosion protected
version according to
→ p. 122, 3.8.3
Terminal compartment
FLSE100-EXS digital
or FLSE100-EXPR
FLSE100-EXS analog *
*: Not for FLSE100-EXPR
**: MCUP Ex zone 2 only
Connection cable analog to Exi *
(Contact position in current-free state)
Ex zone Safe area (or Ex zone 2 for MCUP in Ex zone 2 or CSA CI I, Div2 or CSA CI I, Div 1)
brown
white
green
yellow
white
brown
green
yellow
A Operation/malfunction
B Maintenance
C Check cycle
D Maintenance request
E Limit value
A
BCD
E
Note
For 2-path, 2x1-path or 3x1-path measurement, the
second /third FLSE master and FLSE slave are
connected by use of a junction box with Ex
certification (available from SICK on request) to the
MCUP.
”Point-to-point” wiring for 2-path and 2x1-path
measurement on request.
Service
RS485**
gnd B A
Connection display
Connection Interface module