20 FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH
Important Information
Subject to change without notice
1.4.2 Safety information and protective measures
Protection devices
Preventive measures for operating safety
Avoiding damage
Repairs
NOTICE:
Suitable protection devices and safety equipment for must be available
according to the respective hazard potential for use by personnel.
NOTICE:
The user must ensure that:
Neither failures nor erroneous measurements lead to operational states
that can cause damage or become dangerous
The specified maintenance and inspection tasks are carried out regularly by
qualified, experienced personnel.
NOTICE:
The operator must ensure the following to avoid malfunctions that can directly
or indirectly lead to injuries to persons or material damage:
The responsible maintenance personnel are present at any time and as
quickly as possible
The maintenance personnel are adequately qualified to react correctly to
malfunctions of the measuring system and any resulting operational
malfunctions (e.g. when used for measurement and control purposes)
The malfunctioning equipment is switched off immediately in case of doubt
and that switching off does not cause collateral malfunctions.
NOTICE:
Repairs on explosion-protected system components are possible only by the
device manufacturer and, to a limited extent, also by others.
For detailed information about possible repairs and repair instructions see the
service manual.
To Next Page
Loading...
Need help?
General
