SICK FLOWSIC100 Flare

Start-up and Parameter Settings
FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH 201
Subject to change without notice
4.4.4 Using SOPAS ET to modify display settings
To modify factory settings, open the "MCU-P" device file, enter the Level 1 password and
select the "Parameter / Display Parameter" menu.
Fig. 137 "Parameter / Display Parameter" menu
Entry field Significance
Display language Language version shown on the LC-Display
Display unit
system Unit of measurement system used in displays
Line 1 to 8
Assignment of measuring point to first and second measured value bar in the graphic
display
Value Assignment of measuring variable to the respective measured value bar