SICK FLOWSIC100 Flare

Start-up and Parameter Settings
FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH 165
Subject to change without notice
4.2.1 Entering application-specific parameters in the sender/receiver units
 Start the SOPAS ET program and connect to the measuring system ( → pg. 155, § 4.1.3).
 Select the required device file (FL100-EX xx) and move it to the project window ( → pg.
161, § 4.1.4).
 Set the sender/receiver units to "Maintenance" mode and enter the Level 1 password
(
→ pg. 161, § 4.1.4).
Fig. 99 Setting "Maintenance" mode
 Select the unit of measurement to be used in the "Tools / Options" menu on the over-
view page (metric or US standard), → pg. 165, § 100.
Fig. 100 Selecting the unit of measurements
The respective connected device type is displayed automatically.