SICK FLOWSIC100 Flare

Start-up and Parameter Settings
FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH 155
Subject to change without notice
4.1.3 Connecting to the device
 Connect the USB cable to the MCU control unit ( → pg. 129, Fig. ) and the laptop/PC.
 Start the program in the “SICK\SOPAS” start menu.
 The start page is displayed.
4.1.3.1 Changing the language
 If required, select the desired language in the “Tools / Language” menu ( → pg. 155,
Fig. 84).
 Confirm the dialog shown with “Yes” to restart SOPAS ET with the changed language.
Fig. 84 Changing the language
NOTICE:
The MCU(P) is connected via USB to the laptop/PC.
A serial interface (COM port) is simulated via which the connection is made.