SICK FLOWSIC100 Flare

196 FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH
Start-up and Parameter Settings
Subject to change without notice
4.3.6 Setting Modbus and HART® bus module parameters
4.3.6.1 Modbus module
 Open the "Parameter / System Configuration" directory and select type "RS-485" in the
"Select the installed module" menu (group "Interface Module - Type Selection").
 Set the protocol type and Modbus address in the "Interface module RS-485" field.
Fig. 132 "Parameter / System Configuration" directory
4.3.6.2 HART® bus module
 Open "Parameter / System Configuration" directory and select type "HART" in the
"Select the installed module" menu (group "Interface Module - Type Selection").
Fig. 133 "Parameter / System Configuration" directory
A detailed Modbus specification for parameter setting, read-out of measured
values and data storage is contained on the product CD belonging to the scope
of supply.