SICK MARSIC300

for the MARSIC300 here. Make sure the PC and the MARSIC300 are in the same
subnet and no firewall is active.
Back Enter
Measure
1 Digital outputs
2 Digital inputs
3 Ethernet
I/O config. 3.3
/Diag/I/O
Set the device parameters matching your network in this menu and confirm with
“OK”. A warning appears to confirm that the device is set offline. Confirm with
“Yes”. The network configuration has been changed, however the old configuration
can still be seen. The IP configuration is updated on the operator panel and in
SOPAS ET after a restart (switching the MARSIC300 off and on).
Figure 44: Menu settings IP configuration
After configuration, the MARSIC300 must be adjusted to the network settings of
the customer network.
4.2 Saving parameters
SOPAS ET can be used to backup and restore the MARSIC300 parameters:
4 CONFIGURATION SOFTWARE
40
T E C H N I C A L I N F O R M A T I O N | MARSIC300 8017585/YXD9/V3-1/2017-05 | SICK
Subject to change without notice