°
The cont
rast of the edge
°
The uniform of the material
°
The distance to the next edge
°
Potential spurious edges
•
The teach-in quality depends on the alignment of the MLG-2 and the cleanliness
of the front screens. The value remains until another teach-in process is carried
out.
Process quality (quality of run, QoR)
•
The process quality indicates the quality of the light level currently being received.
The MLG-2 analyzes the quality of the current edges and compares this to the val‐
ues after the last material teach-in process.
Depending on the MLG-2 variant and from the parameterization, you can call up the
teach-in quality and the process quality as follows:
•
SOPAS ET
•
Switching outputs
7 COMMISSIONING
50
O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker 8025190/2020-01-13 | SICK
Subject to change without notice
To Next Page
Loading...
