4. Align the sender and receiver with each other.
5. Cle
an the position of the sender and receiver. Screw tightening torque:
2.5 to 3 Nm
Mounting bracket for the fieldbus module
If you are using the FlexFix bracket, you will need a mounting bracket for the fieldbus
module.
Figure 33: Mounting bracket for the fieldbus module
1
FlexFix bracket
2
Mounting bracket
1. Use the M5 x 6 screw provided to fasten the mounting bracket on the fieldbus
module.
2.
Use an M5 screw with a sliding nut, for example, to mount the mounting bracket
on an industrial profile.
5.3.3 Turning the fieldbus module on the MLG-2
All connections of the fieldbus module are provided on one side. You can mount the
f
ie
ldbus module rotated by 180° so you can feed the cables in from the front or the
back.
5 MOUNTING
40
O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker 8025190/2020-01-13 | SICK
Subject to change without notice
To Next Page
Loading...
