SICK MLG-2 WebChecker User Manual

Prerequisites:
•
The ML
G-2 was set up for edge measurement.
1. Parameterize the desired function on the “Enhanced Sensing” page in the “Func‐
tional configuration” menu.
✓
The result is on the “Start” and “Enhanced Sensing” pages.
More information:
•
see "“Functional configuration” menu", page 101
Example
1 2
211
2
Figure 52: Results for “Functional configuration” examples, “Enhanced Sensing” page
1
Result for "F1: Calculation of the width between edges E1 and E10” function
2
Result for "F2: Calculation of the width between the center positions of edges E1 and
E10” func
tion
9.5 Other configurations
You can run the following configurations via SOPAS ET.
For e
xample, the following configurations are possible depending on the MLG-2-variant:
•
Configure PIN of the M12 male connector on the receiver see "“General settings”
area", page 91.
•
Parameterize analog outputs.
•
Parameterize switching output and inputs see "“Digital configuration” menu",
page 103.
•
Configure bus systems.
9 C
OMMISSIONING VIA SOPAS
62
O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker 8025190/2020-01-13 | SICK
Subject to change without notice

SICK MLG-2 WebChecker Specifications

General

Brand	SICK
Model	MLG-2 WebChecker
Category	Measuring Instruments
Language	English