SICK MLG-2 WebChecker - T-connector for MLG-2 WebChecker connection

Table 22: Pin assignment, sender connection
Male connector Pin Signal Meaning Color
12
3 4
5
1 L+ 24 V supply voltage Brown
2 Sync_A Synchronization White
3 M GND supply voltage Blue
4 Test_In Test input Black
5 Sync_B Synchronization Gray
6.3 T-connector for MLG-2 WebChecker connection
Figure 37: Connection with T-connector
1
Sender
2
Receiver
3
Fieldbus module
4
T-distributor
5
Power supply
6
Fieldbus
A T-connector is available for the MLG-2 WebChecker, which is used to connect the
sender and f
ie
ldbus module to one another, as well as provide facilities for connecting
the voltage supply, the switching output 1, and the test input.
ELECTRICAL INSTALLATION 6
8025190/2020-01-13 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker
45
Subject to change without notice