SICK MLG-2 WebChecker - Reset to factory settings

ca. 1/3
ca. 2/3
max. 2.5 m
Figure 44: Performing material teach-in
2. Press the T
e
ach pushbutton for less than 1 s.
3. Wait until material teach-in is complete.
✓
The yellow LED on the receiver and the Alignment LED are on.
8.5 Reset to factory settings
NOTE
Aft
er a reset, sensor alignment, sensor teach-in and material teach-in are required.
1. Press T
e
ach pushbutton for 40 seconds.
✓
All settings are reset to the factory settings.
8 O
PERATING MLG-2 VIA CONTROL PANEL
54
O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker 8025190/2020-01-13 | SICK
Subject to change without notice