SICK MLG-2 WebChecker User Manual

If the teach-in process is successful, the yellow LED on the front and the Alignment LED
g
o out. The MLG-2 is operational.
If the teach-in process is unsuccessful, the Alignment LED flashes rapidly, as does the
red LED on the front of the device.
b
Check that the MLG-2 is correctly aligned, that the front screens are clean, and
that there are no objects located in the light path.
b
Then carry out the teach-in process again.
8.3 Performing sensor teach-in
NOTE
You c
an perform other settings for sensor teach-in via SOPAS ET.
NOTE
All MLG
-2 light beams must be free one time for sensor teach-in.
The light path must be free for sensor teach-in via pushbutton since there is no start/
st
op. The sensor teach-in is started and immediately stopped after the pushbutton is
pressed. However, the light path can be exposed bit by bit using all other interfaces.
Prerequisites
•
Sensor alignment was successfully completed.
1. Expose all light beams once at the same time.
✓
Sensor teach-in starts.
✓
The Alignment LED flashes slowly (1 Hz).
✓
The yellow LED on the receiver flashes slowly (1 Hz).
2. Press the Teach pushbutton for 1 s to 5.
3. Wait until sensor teach-in is complete.
✓
The yellow LED on the receiver is off.
✓
The Alignment LED on the control panel of the receiver is off.
If the sensor teach-in process has been unsuccessful, the red LED on the receiver will
flash rapidly (10 Hz).
8.4 Performing material teach-in
NOTE
You c
an perform other settings for material teach-in via SOPAS ET.
Prerequisites
•
S
ensor t
each-in was successfully completed.
1. Place all objects to be detected at the correct distance between the sender and
receiver.
OPERATING MLG-2 VIA CONTROL PANEL 8
8025190/2020-01-13 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker
53
Subject to change without notice

SICK MLG-2 WebChecker Specifications

General

Brand	SICK
Model	MLG-2 WebChecker
Category	Measuring Instruments
Language	English