Alarms and alerts 9810 series - User manual
191 7EN05-0390-08
Example: Setpoint learning duration in an unstable system
In this example, the learning duration is 30 days. Because the system is not stable for 7.5 days
(one quarter of the 30 days) learning is complete at the end of the maximum learning duration.
For more information on Sag/Swell, Setpoint, and Relative Setpoint modules, see ION Reference,
available on www.usa.siemens.com/pds.
Implementing standard alarm setpoint learning using ION Setup
You can use ION Setup to implement setpoint learning, which analyzes your power system and
recommends settings.
NOTE: To learn valid setpoint values the meter’s power system must be stable.
To implement setpoint alarm setpoint learning using ION Setup:
1. Start ION Setup.
2. Open the Setup Assistant for your meter.
To Next Page
Loading...
Need help?
General
