5.
Press or to highlight the desired volts mode from the list, in this case, 3W-WYE.
Press to select the highlighted volts mode. A confirmation screen is displayed, showing
your meter’s previous setting and newly selected setting.
6.
Press to confirm, and the new setting is applied to your meter. Press to cancel and
maintain your meter’s original setting.
7.
In the Volts Mode screen, press to go to the PT/CT Setup screen.
8.
In the PT/CT Setup screen, press to highlight the potential transformer (PT) or
current transformer (CT) value for editing. Press to edit the highlighted value.
NOTE: If you have exceeded the password timeout period, you are prompted to enter your
meter’s display password.
9.
Press to change the value of the highlighted digit (0 - 9). Press to go to the next digit.
Press to enter the new value. When the confirmation screen is displayed, press to
confirm the new value or to revert to the original value.
Display setup
You can configure basic display parameters using the display.
9810 series - User manual Display
7EN05-0390-08 172
To Next Page
Loading...
Need help?
General
