Menu Submenu
Meter Setup Volts Mode
PT/CT Setup
Voltage Polarity Setup
Current Polarity Setup
Nominal Values
Ethernet Port Enable Setup Ethernet Port Enable Setup
Communications Setup IPv4 Assignment Mode Setup
Stored IPv4 Address Setup
IPv6 Link Local Address
IPv6 Assignment Mode Setup
Stored IPv6 Global Address
Ethernet Device Name
DNS Setup
COM1 Setup
COM4 Setup
NTP Address
SMTP Address
Display Setup Screen Setup
Label & Symbol Setup
Numeric Format Setup
Date/Time/Clock Setup Date & Time Setup
Clock Setup
Alarm Setup Alarm Setup
Language Setup Language Setup
Time of Use Setup TOU Active Rates
TOU Season
Resets Resets
Meter setup using your display
Navigate to Setup screens and enter parameters to configure your meter.
Your meter’s default display password is 0 (zero).
NOTE: Your meter locks you out of display configuration after you have exceeded the maximum
number of attempts to enter a password.
The following example shows how to use the navigation icons to select parameters, enter numeric
information or select parameter values from lists.
9810 series - User manual Display
7EN05-0390-08 170
To Next Page
Loading...
Need help?
General
