Revenue 9810 series - User manual
279 7EN05-0390-08
LED behavior Revenue lock status
Off The meter is not revenue locked.
On The meter is revenue locked.
Flashing
New revenue lock state is pending; power cycle your meter to set the
revenue lock to on or off.
Revenue locking your meter
You can lock and unlock your meter using the revenue lock switch located on the meter base.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
Failure to follow these instructions will result in death or serious injury.
•
Apply appropriate Personal Protective Equipment (PPE) and follow safe electrical work
practices. See NFPA 70E, CSA Z462 or other local standards.
•
Turn off all power supplying this device and the equipment in which it is installed before
working on or in the equipment.
•
Always use a properly rated voltage sensing device to confirm that all power is off.
1. Open the revenue lock switch cover.
2. Locate the revenue lock switch.
3. Toggle revenue lock switch on or off.
4. Close the revenue lock switch cover and make sure it is firmly in place.
5. Seal the revenue lock switch cover if required.
Anti-tamper sealing
The meter has several anti-tamper sealing points which can be sealed by a wire seal or lock.
In certain countries, the meter is no longer revenue certified if the anti-tamper seals are broken.
See your meter’s installation guide for sealing point locations.
NOTICE
LOSSOF COMPLIANCE
Failure to follow these instructions may render your device non-compliant for billing
purposes.
Re-certify your meter with the appropriate revenue metering authorities if you remove the anti-
tamper seals.
Revenue lock switch seal
To Next Page
Loading...
Need help?
General
