CLINITEK Status+ Analyzer Operator’s Guide 109
System Configuration
b. Select Next.
c. When you finish, select Done 3 times to return to the Select
Ready screen.
Power Save • Enabled activates Power Save
mode.
If you power the system from
an electrical outlet and the
system remains idle for 5
minutes, the system pulls in
the test table and powers
down.
If you power the system by
batteries, Power Save is
always activated. After the
system remains idle for 5
minutes, it powers down.
• Disabled (default)
deactivates Power Save mode
if you power the system from
an electrical outlet.
Screen 2 of 2
Sound • Sound on (default) plays a
range of audible tones when
you select an area, button, or
key on the screen. Also, a
tone sounds if you have a
problem performing a task.
Sounds range from a single
beep to a click.
• Sound off does not play any
audible tones.
• Key clicks only sounds an
audible click when you select
an active button or key on the
screen.
System Settings Option Description
To Next Page
Loading...
