CLINITEK Status+ Analyzer Operator’s Guide 115
System Configuration
• To allow all operators to gain access to the system without
entering their name, select Disabled.
5. Select one of the following options:
•If you selected Enabled, add at least 1 operator, as explained
in Add an Operator‚ page 115.
•If you selected Disabled, select Done 3 times to return to the
Select Ready screen.
Note If the CLINITEK Status+ analyzer loses power, the system
retains the operator IDs.
Add an Operator
You can add up to 700 operators.
Note If you do not add any authorized operators and no operators
display in the list, be sure to return to the Select Ready screen. That
way, the system disables the Authorized Operator setting and you can
continue to gain access to the system.
To add an operator, perform the following steps:
1. On the Select Ready screen, select Instrument Set Up.
2. On the Choose Settings screen, select Instrument Settings.
3. On the Instrument Settings screen, select Authorized Operator.
4. On the Authorized operator screen, select Add operator.
5. On the Operator ID screen, enter an operator name.
6. Select Enter.
The Authorized Operator screen displays, indicating the operator
name and which functions the operator can perform.
CAUTION
After you add an operator, if you enable or disable the
Authorized Operator setting, the system deletes all the
patient test results.
To Next Page
Loading...
Need help?
General
