CLINITEK Status+ Analyzer Operator’s Guide 161
Glossary
authorized operator Operators who can perform certain tasks,
where they gain access to the analyzer by
entering their operator ID to perform those
tasks.
auto-check Performs automatic strip quality checks and
provides results in about 1 minute.
automatic strip
identification
Automatically identifies an ID band strip type
with no need to select it from a menu.
baud rate The speed of data transmission in bits per
second (bps) between the analyzer and a
remote device.
calibration The analyzer reads the white calibration bar
at the appropriate wavelengths to ensure
accurate test results.
cancel To end a sequence or anoperation.
comment A notation the operator enters for a QC test
result.
configuration System hardware and software settings that
adjust or configure some aspect of the
analyzer.
conventional unit Unit of measurement for test results.
control Objects that display on the software UI that
the operator can manipulate. Buttons,
boxes, and optionbuttons are examples of
controls.
Solution containing a known level of
analytes.
countdown A numeric display that indicates the amount
of time left in an operation.
Custom set up Patient, operator, and sample appearance
custom settings.
data entry The act of entering data such as a patient or
operator ID into the analyzer.
data entry box A software UI object which displays the data
that the operator entered.
Term Definition
To Next Page
Loading...
