Siemens CLINITEK Status+ - Page 67

CLINITEK Status+ Analyzer Operator’s Guide 67
Troubleshooting
Note If you cannot troubleshoot an error, contact your local technical
support provider or distributor, as described in Appendix B, Support
Information.
Error
Code
Error Message Action
E01 Low battery power The battery level is too low to power
the analyzer.
Replace the batteries by using any of
the following instructions:
On the screen, select Error Report to
view the instructions.
See Section 4, Maintenance,
Changing the Batteries‚ page 63.
Change the Power Save setting to
extend the battery life. For details,
see Section 7, System Configuration,
Changing the System Settings‚
page 107.
E02 Failure of
calibration data
Contact your local technical support
provider or distributor.
E03,
E04,
E05,
E06,
E07,
E08,
E21,
E22,
E90,
E91, E92
or E93
Failure of
computer software
Contact your local technical support
provider or distributor.
E10 or
E48
Loss of test results 1. Power off the analyzer by
pressing the on/off button for 2
seconds.
2. Power on the analyzer by
pressing the on/off button.
3. Repeat the test.