Preparing the Engineering
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 243
DC8-037-2.02, Edition 10.2017
7.2.3.1 Prerequisites
Prerequisite for the operation of the SICAM Device Manager is the usage of an appropriate
PC, that must fulfill certain hardware requirements.
For the installation of the SICAM Device Manager the following preconditions are required:
• USB interface must exist
• DVD drive must exist
• C:\ drive must exist
• File system NTFS be existing
• Administrator rights for operating system Microsoft Windows
®
(read and write rights to the
file system and the Windows Registry)
• Installed TCP/IP
• Enabled DirectX features
• 30 GB free harddisk memory
• 4 GB installed main memory
The memory requirements and also the hard disk space of the operating system and all appli-
cations running parallel to the SICAM Device Manager (Microsoft Office etc.) and/or memory
usage of onboard graphic adapters have to be considered.
To make sure that DirectX features are enabled on your PC
• Click the Start button, type dxdiag in the search box, and then press the enter key
• Click the System tab and then, under SYSTEM INFORMATION, check the DirectX version
number, e.g.: DirectX 11
• Click Next page
• Under DirectX Features all features must be enabled
For the SICAM Device Manager the following operating systems are supported:
Operating system Hardware
Microsoft Windows 7
®
64 Bit PC, Notebook
Microsoft Windows 8
®
64 Bit PC, Notebook
Microsoft Windows 10
®
64 Bit PC, Notebook
Microsoft Windows Server 2008 R2
®
64 Bit PC, Notebook
Microsoft Windows Server 2012 R2
®
64 Bit PC, Notebook
DirectX version depends on the used operating
system
To Next Page
Loading...
Need help?
General
