Siemens CP-8022 User Manual

Engineering via SICAM WEB
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 369
DC8-037-2.02, Edition 10.2017
9.1.11.3.1 Parameters with Assignment on the I/O Master Module
This data can be changed – for each category – in the table for the signal generation:
Processing type Parameter Meaning
SW_CO_INTER – com-
mand interlocked
–
SW_DI – Software Data
Point Digital Input
–
SW_DO – Software Data
Point Digital Output
–
SW_LOC_REM – local
remote criterion
SID-BSE Source identification basic system element
SID-ST Source identification station number if mul-
tipoint traffic mode 0…99 if R-SID 0…254; if
automatic, the SID will be learned
SID-SSE Source identification supplementary system
element
SW_REV – Revision SID-BSE Source identification basic system element
SID-ST Source identification station number if mul-
tipoint traffic mode 0…99 if R-SID 0…254; if
automatic, the SID will be learned
SID-SSE Source identification supplementary system
element
SW_CONTROL LOCA-
TION – control location
SID-BSE Source identification basic system element
SID-ST Source identification station number if mul-
tipoint traffic mode 0…99 if R-SID 0…254; if
automatic, the SID will be learned
SID-SSE Source identification supplementary system
element
ACTCON_yes_no Sending of ACTCON and ACTTERM
SW_CO_EA – command
error acknowledgement
–
SW_DO_TE-6460 –

Siemens CP-8022 Specifications

General

Brand	Siemens
Model	CP-8022
Category	Controller
Language	English