Engineering via SICAM WEB
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 451
DC8-037-2.02, Edition 10.2017
When the generation of the backup file has finished, the following dialog appears:
• Click on Start download
The storing procedure may vary dependent on the used web browser and may take some
time, depending on the file size and transmission rate. Follow the instructions of your web
browser. The file name is put together of
SICAM_A8000_BACKUP_<customer>_<plant>_<station>_<hash value of file>.cmc.
• After successful generation click on in order to close the dialog
Note
The file saved via SICAM WEB can not be imported into the SICAM TOOLBOX II.
9.3.3 Restore Device Settings
This function gives you the possibility of restoring and loading all previously backed up set-
tings and parameterizations into the device.
With this procedure, all telecontrol parameters, instruction list and firmware codes are stored
jointly on the SD card in the Master Module.
Select thereto the submenu Restore device settings .
You have the possibility to abort the procedure.
To Next Page
Loading...
Need help?
General
