Station: Updating the FW of the main CPU and additional CPUs
22
122 | 178
3. Click on 'OK' in the 'Information' window.
a The following window is opened:
4. Select 'Run in background' in order to run the firmware update in the
background while continuing to work in Cerberus-Engineering-Tool.
a The active firmware update is indicated by the symbol on the right-
hand side of the status bar.
a Pop-up windows in the bottom right-hand corner of the software will notify
you when the firmware download and the firmware update are complete.
a After the restart, the 'Station' display shows the available BDVs. It is not
necessary to install a ↑ BDV at this point.
22.2.4.3 Starting the firmware update in Cerberus-Engineering-Tool
1. Select 'Initiate update from tool'.
2. Select the connection type.
a The available 'Station' are displayed.
3. Select the 'Station' you want.
– The available 'Stations' are preselected. If a 'Station' is available but not
preselected and a time stamp has been entered in the 'System status'
column, specific system data has been modified on the 'Station' but not yet
saved. The specific system data is deleted when you update the firmware.
NOTICE! Save the configuration data before updating the firmware.
To Next Page
Loading...
