and communication with 'Station'
Loading configuration from the PC to the station
4
30 | 178
4.7 Loading configuration from the PC to the station
You can use the 'Download site' function to load the configuration of one ↑ 'Site'
from the Cerberus-Engineering-Tool on the PC into the ↑ 'Station'.
NOTICE
network configuration in '
'Site'
When the selection displayed for 'Download site' is manually modified, in special
cases
1
it may be necessary to reset a 'Station' to the factory setting as well as a
'Initialize station'.
● Do not modify the selection displayed for 'Download site' in normal cases.
● Check the sequence when loading different configuration states in special
cases
1
.
● After any change of the network configuration, make sure that all 'Stations' in
the 'Site' for the 'Download site' procedure are selected and can be accessed.
● Temporarily update non-accessible 'Stations' to the latest status of the global
network configuration prior to integration in the network.
1
Examples of special cases:
● A 'Station' will be added to a networked 'Site' and a new network configuration
will be loaded upon initialization of this 'Station', different from the global
network configuration of the connected 'Site'.
● During the 'Download site' procedure a 'Station' is temporarily not accessible.
Both examples can result in the 'Station' no longer starting after the 'Download site'
procedure and the above actions having to be carried out.
If you use a number of network cards on the PC, observe the information in the
chapter 'IP settings for several network cards' in document A6V10210424. See
chapter 'Applicable documents'.
To Next Page
Loading...
