Siemens FS720 - Calibration Report

Calibrating an FDnet/C
-
NET detector line
Calibration report
13
61 |
178
Building Technologies
A6V10210416_j_en_
--
Fire Safety
2018
-
08
-
29
13.3 Calibration report
The calibration report contains the main measurement results or the calibration
figures for a line calculated from these results.
Displaying the calibration report on the 'PMI'
w Required access level: 3
1. Open the following path in the main menu on the 'PMI':
'Topology' > 'Hardware tree' > 'Station xx' > 'C-NET line card xx'
a The display shows the menu for the line card in question.
2. In the 'C-NET line card xx' menu, highlight the line for which you require the
calibration report.
3. Select the 'More options' function in the softkey bar.
a The display shows a list.
4. In the list, select the following: 'Execute commands' > 'Calibration report'
a The display shows the calibration report.
5. Use the navigation keys to navigate through the entries in the calibration report.
You will find more information about the individual entries in the section
'Calibration report' below.